Simple hair rig

These are the components needed to tie the rig.The rig we are
going to tie is a basic hair rig using the knotless knot for the hook/hair
and a palmor knot for attaching the swivel.

step 1

First cut a piece of hooklink about 12" and tie a small overhand loop in one end

step 2

Next thread your chosen hookbait onto the loop using a baiting needle and secure with a boilie stop.

step 3

Thread end of hooklink through the eye of the hook from the back .

step 4

Whip the hooklink down the hook six times.

step 6

Now pass the end of the hooklink through the eye again from the back.

step 7

Pull the knot tight and you should now have a simple knotless knot hair rig as shown.

Palmor knot part 1

Make a loop in the hooklink around 3" and pass through the swivel.

Palmor knot part 3

Pass the swivel through the loop

Palmor knot part 2

Tie a loose overhand knot in the poop as shown.

The finished rig.

Tighten the knot by pulling the swivel while holding the hooklink and tag end. You will now have a rig that looks something like this. All that is needed is to trim off the tag end and you will have a completed rig.